Skip to content
  • There are no suggestions because the search field is empty.

How do I access configuration mode on my HandHeld or Wireless Kill Switch

Make sure the H212/H106 handheld is powered off. Then:

  1. Press and hold the Red button
  2. Press and hold the Green button
  3. Release the Red button
  4. Continue holding the Green button for a few more seconds until the two LEDs become solid.
  5. Release the Green button immediately after the red LED turns solid.

DO NOT CONTINUE TO HOLD THE GREEN BUTTON AFTER THE RED LED TURNS SOLID OR ELSE YOU MAY NOT BE ABLE TO SAVE ANY SETTINGS.

You should now be in Config mode.

Note: Some systems will require a password to make changes to certain settings. If you are an Operator or Fleet Owner, please consult with your Equipment Dealer or Manufacturer.

Note:  Some configuration features require the C220 to be powered up and linked with the H212/H106 before any changes can be made.

Left/Right scrolls through the list of available settings. Up/Down selects the options for each setting. Once you are satisfied, press the Green button to save your options or the Red button to cancel and exit. 

After saving, exit the config mode by pressing the Red button. 

Power up the system normally and your new settings will be active.