Skip to content
Request Support View Tickets Sign in
  • There are no suggestions because the search field is empty.

How do I match my Wireless Kill Switch

For Quick Start Guide, Please go to the link below:

H106 Wireless Kill Switch Start Guide

How to match using the magnets (Method 1):

To match a H106 Wireless Kill Switch with a C220 receiver, you must get both units into match mode.

To get the C220 receiver into match mode, follow these instructions:

 

There are two magnets on the back of the H106 Wireless Kill Switch and we have a sensor under the Aarcomm logo at the top left corner of the C220 receiver. Waive the two magnets across the sensor under the logo back and forth once. The light on the receiver will change from a white / light blue colour to a dark blue when the C220 receiver is put into match mode.

 

Once the C220 receiver is in match mode (it will timeout in 60 seconds if you don't finish the matching procedure), it is time to put the H106 Wireless Kill Switch into match mode. To do this:

  1. Make sure the Wireless Kill Switch is powered off before continuing to the next step.
  2. Hold down the RED BUTTON. When the RED BUTTON is held down, you will see the red LED to go on.
  3. Then, with your other hand, hold down the two left GREY ROUND BUTTONS and this will cause the green LED to go on.
  4. When both the red and green LEDs are on, take your fingers and thumb off the buttons. The screen will then say, “match mode” and then a few seconds later “match mode successful"

Turn off the receiver and then turn both the Wireless Kill Switch and the receiver on again. Your system is now ready to operate.

How to match using a power switch (Method 2):

This method is similar to Method 1 except that you can get the C220 receiver into matching mode by toggling the power on and off about 6 to 7 times. This method is useful if you cannot physically access the C220 because it is installed in a location that is difficult to reach. 

Since you may not be able to see the C220 LED colour, it is recommended that you put the H106 Wireless Kill Switch into matching mode first. Then you can look at the H106 screen for a "Match Successful" message while you are toggling the C220 power.

1. Start with turning both the H106 Wireless Kill Switch and C220 receiver off.

2. Put the H106 Wireless Kill Switch into matching mode:

  1. Hold down the RED BUTTON. When the RED BUTTON is held down, you will see the red LED go on.
  2. Then, with your other hand, hold down the two left GREY ROUND BUTTONS and this will cause the green LED to go on.
  3. When both the red and green LEDs are on, take your fingers and thumb off the buttons. The H106 screen will then say, “match mode” and then a few seconds later “match mode successful.

3. Once the H106 is in matching mode, you will have about 60 seconds to put the C220 into matching mode. Do this by toggling the C220 receiver power on and off 6 to 7 times:

  1. Power ON the C220 for 1 second
  2. Power OFF the C220 for 1/2 second
  3. Repeat this sequence 6 to 7 times
  4. On the 6th time, keep the power ON
  5. At this point, the screen on the H106 Wireless Kill Switch should show "Match Successful"

If you see “Match Failed”, it could mean:

The C220 was not powered on or did not enter match mode (the C220 is in match mode when the LED is dark blue), and the H106 waited too long and timed out after 60 seconds. When the H106 is put into match mode, it should match with a C220 that is in match mode within a few seconds.

OR

There is incompatible software on the H106 and C220. Please contact our support team for further assistance.